Inserting & Removing The Rubber Boot; Inserting New Batteries - palintest MICRO 500 Operating Instructions Manual

2.3 Inserting & Removing the Rubber Boot
1 To remove meter from rubber boot, push out from the
bottom edges of meter until it is completely out of boot.
Ensure that the cables of pH electrode or temperature
probe are not connected.
2 To insert meter into rubber boot, slide in from the top of
meter before pushing the bottom edges of meter down to
set it into position. Lift up the stand at the back of meter
for bench top applications if necessary :

2.4 Inserting New Batteries

The battery compartment is found at the back of instrument.
To open the battery compartment, push in the direction of
arrow and lift up the cover. Note the polarity of battery
before inserting into position. After replacement, place
cover back and press down until it locks tight :
5 of 21 INST.21