Tape Roll Diameter; Tape Application Leg Length - Standard; Tape Application Leg Length - Optional; Box Board - 3M -Matic 200a Instructions And Parts List

4-SPECIFICATIONS (continued)
Specifications

4.6 Tape Roll Diameter

Up to 405mm [16 inch] maximum on a 76mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
4.7 Tape Application Leg Length – Standard
70 mm ± 6mm [2.75 inch ±. 25 inch ]
Tape Application Leg Length – Optional
50 mm ± 6mm [2 inch ±. 25 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")

4.8 Box Board

Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)

4.9 Box Weight and Size Capacities

A. Box Weight, fi lled: 5 lbs.–65 lbs. [2.3 kg–29.5 kg]. Contents must support fl aps.
B. Box Size:
Length –
Width –
Height –
*
Cartons narrower than 250mm [10 inch] in width may require more frequent belt replacement
because of limited contact area.
** 90mm [3.5 inch] height with heads adjusted to apply 50mm [2 inch] tape leg lengths.
(See "Special Setup Procedure—Changing the Tape Leg Length".)
*** 165mm [6.5 inches] minimum to 725mm [28.5 inches] maximum height with columns adjusted to
upper position. (See "Special Setup Procedure – Box and Machine Bed Height Range".)
Note: The case sealer can accommodate most boxes within the size range listed above.
However, if the box length (in direction of seal) to box height ratio is 0.6 or less, test run
several boxes to ensure proper machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL
Any box ratio approaching this limitation should be test run to ensure performance.
200a-NA
Minimum
150mm [6.0 inch]
150mm [6.0 inch]*
120mm [4.75 inch]** ***
BOX HEIGHT
®
fi lm tapes.)
Maximum
Unlimited
550mm [21.5 inch]
620mm [24.5 inch] ***
= SHOULD BE GREATER THAN 0.6
13
2011 June