Assembly Completion - 3M -Matic 200a Instructions And Parts List

7-INSTALLATION (continued)
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head
to the frame and remove the polystyrene blocks
(Figure 7-4).
Figure 7-4
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame (Figure 7-5).
Figure 7-5
Buffing
Roller
Figure 7-7
200a-NA
B
C
Cable
Tie
WARNING
Sharp Knife
Cut the plastic ties holding the lower
taping head in position (Figure 7-6).
Figure 7-6

7.6 Assembly Completion

1 Crank - Install the crank handle on the top of
the left column as shown (Figure 7-7B).
2 Tape Drum Bracket - Install the upper tape
drum bracket on the top cross bar as shown
(Figure 7-7A).
3 Stop Bracket - Raise upper head assembly
(turn crank handle counterclockwise) and
install the two stop brackets (provided in the
parts bag). Use lower set of holes as shown
in Figure 7-7D. The upper set of holes should
only be used when both taping heads are
adjusted to apply 50mm tape legs.
A
D
18
2011 June