Regulatory Information - Alarm.Com LTE Module Installation Manual

Before the customer can configure their website account, the Alarm.com account for that customer must be created on
the Partner Portal, and the LTE module associated with the account must be installed successfully.
To log in and access their account, the customer can go to
complete the new subscriber setup procedure.
The customer needs the following:
• The website login and temporary password included on the Alarm.com Welcome Letter generated when the
account was created by the Dealer.
• A list of their system sensors and touch screens with corresponding zone IDs.
• At least one phone number and e-mail address where notifications can be sent.
Note: At least one sensor must be learned into the panel to complete the new subscriber setup. If not all sensors and
touch screens were learned in before powering up the module, an updated sensor list must be requested by performing
an LTE phone test or requesting an updated equipment list from the Partner Portal.

Regulatory Information

Changes or modifications not expressly approved by Alarm.com can void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different form that which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your
body.
Listings - FCC ID: YL6-143470L, IC: 9111A-143470L
https://answers.alarm.com/?title=ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simo...
www.alarm.com (or custom dealer website address) to
Updated: Wed, 29 Jan 2020 21:50:59 GMT
27