Alarm.Com LTE Module Installation Manual page 17

Menu
--- Number of Z-Wave Devices
2
--- Add Z-Wave Device
--- Remove Z-Wave Device
2
--- Z-Wave Home ID
-- Account Creation
1
--Image Sensor Setup
1
--- Learn Image Sensor
--- Delete Image Sensor
https://answers.alarm.com/?title=ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simo...
2
2
1
Description
The total number of Z-Wave devices currently known to
the LTE module.
Press OK to enter Z-Wave Add Mode. Make sure the
device you are trying to add is powered up and within 3
to 6 feet of the Simon XT or XTi panel. Refer to the
manufacturer's instructions for button presses required to
enroll device.
Press "OK" to remove an existing Z-Wave device, or to
"reset" a Z-Wave device that was previously learned into
a different Z-Wave network. Previously enrolled devices
must be reset before they can be enrolled into the
module.
Press "OK" to query the Z-Wave network Home ID. If the
ID is 0, verify that the module has communicated with
Alarm.com and that the Alarm.com account is set up for
Z-Wave.
This menu is available only to installers who have their
own Alarm.com account creation system. You must enter
a Technician ID and a Lead ID in order to use this menu.
An Image Sensor daughterboard is required to enable
Image Sensor capabilities on the module. The Image
Sensor daughterboard comes built into AT&T LTE
modules.
Press "OK" to enter Add Mode. Enroll the Image Sensor
by inserting batteries or resetting.
Press "OK" and scroll to the Image Sensor to delete.
Press "OK" to delete.
Updated: Wed, 29 Jan 2020 21:50:59 GMT
17