Alarm.Com LTE Module Installation Manual page 18

Menu
---Image Sensor Settings
1
----Image Sensor #[x]
1
-----[Power Information]
1
-----Signal
1
-----Test PIR
1
-----PIR Sensitivity
-- Dealer Logo Update
System Test + Installer Code
- Interactive Services
https://answers.alarm.com/?title=ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simo...
1
Description
Press "OK" and scroll to the Image Sensor of interest.
Press "OK".
[x] is the sensor ID. Press "OK" to view information on
this Image Sensor.
Gives information on the Image Sensor's battery level
and power status.
The signal strength of the communication between the
Image Sensor and the Image Sensor daughterboard.
Press "OK" to put the Image Sensor in PIR Test Mode.
Press "OK" to view current selection. Scroll down to view
available sensitivity levels. Press "OK" to select.
This menu is used to upload a Dealer logo to the two-
way talking touchscreen (2WTTS). (Only available for
dealers who have set up this feature with Alarm.com.)
Press "OK". If a logo is NOT available for upload to the
2WTTS, you will see "Logo update not available". If a
logo is available, you will be asked to wait until the
panel's LEDs start flashing, then wait until the panel's
LEDs stop flashing – at which time the logo should show
on the 2WTTS.
Scroll down to System Test, enter the Installer Code and
press OK
Scroll up to Interactive Services and press OK
Updated: Wed, 29 Jan 2020 21:50:59 GMT
18