Alarm.Com LTE Module Installation Manual page 26

Menu
----Thermostats
----Lights
----Locks
2
--- Advanced
2
---- Rediscovery
2
---- Replicate Mode
2
---- Send Node Info
---- Refresh Thermostat
[1] An Image Sensor daughterboard is required to enable Image Sensor functionality. All AT&T LTE modules include a
built-in Image Sensor daughterboard. For general information on how to determine if the Image Sensor radio is built into
the module, see Built-In
image capabilities and features.
[2] Refer to the emPowerTM installation instructions and guides on the Alarm.com Dealer Site for more information on Z-
Wave enrollment and troubleshooting.
Walking the customer through new user setup using the Customer Website:
Note: This only applies to customers on an interactive service package with an online account. This step is not
required for customers that use the module for wireless signaling only.
https://answers.alarm.com/?title=ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simo...
2
Radios. An interactive Alarm.com account with an Image Sensor service package is required for
Description
View thermostat data and update/remove thermostats
from display on the panel and touch screens.
Update the lights list shown on the panel and touch
screens.
Update locks list shown on panel and touch screens and
pair locks with their door contact sensor.
Provides additional functionality for advanced Z-Wave
troubleshooting and configuration.
Network rediscovery allows the system to determine the
most efficient communication patch between Z-Wave
devices. (During this process the Z-Wave network is
busy and cannot respond to other commands.)
Initiates replicate mode on the panel.
For advanced use only. Do not use unless directed to do
so by Alarm.com.
Requests updated thermostat data.
Updated: Wed, 29 Jan 2020 21:50:59 GMT
26