Led Functions - Alarm.Com LTE Module Installation Manual

LED Functions

LED
L1
L2
L3
L4
L5
LED L1 (red)
L1 flashes when there is an error. The number of flashes indicates the error number. If there are two or more errors at
the same time, the errors will flash one after the other. The LED will stay off for at least four seconds between errors.
The following table shows the errors flashed on L1:
Number of flashes
1
https://answers.alarm.com/?title=ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simo...
Function
Error LED. Flashes one to eight times in an eight-second
interval to indicate specific error. For more information
about L1 errors, see LED L1
Panel Communication and Z-Wave status messages.
Flashes every time the module communicates with the
panel and flashes in patterns to indicate Z-Wave status.
LTE Communication. Flashes every time the LTE signal
level is checked and when packets are exchanged with
Alarm.com.
LTE Signal Level. Flashes zero to five times to indicate
signal strength, or toggles on/off slowly when
communicating with Alarm.com servers.
Z-Wave Error LED. For more information about L5
errors, see LED L5 (yellow).
Error and solution
Module cannot communicate with the panel.
Perform a power cycle on the panel. If the error persists
lift the module out of the panel and re-insert it. If the error
is still observed try a different module. Finally, if that
does not fix the problem try a different panel.
(red).
Updated: Wed, 29 Jan 2020 21:50:59 GMT
10