Alarm.Com LTE Module Installation Manual page 21

Menu
---- Last Temp. Read
-- Request Weather Update
[1] An Image Sensor daughterboard is required to enable Image Sensor functionality. All AT&T LTE modules include a
built-in Image Sensor daughterboard. For general information on how to determine if the Image Sensor radio is built into
the module, see Built-In
image capabilities and features.
[2] Refer to the emPowerTM installation instructions and guides on the Alarm.com Dealer Site for more information on Z-
Wave enrollment and troubleshooting.
Table 6: XTi Interactive Services Menu
Menu
System Programming + Installer Code
- Interactive Services
-- Module Status
1
-- Image Sensor
1
---Status
1
----Set PIR Sensitivity
https://answers.alarm.com/?title=ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simo...
Radios. An interactive Alarm.com account with an Image Sensor service package is required for
Description
For troubleshooting only. Shows how many unsuccessful
attempts were made by the LTE module at trying to
communicate with the Z-Wave thermostat. A low number
of 0 or 1 is normal.
Press OK if the weather forecast is not showing on the
touch screen (2WTTS).
Description
Scroll to Programming and enter the Installer Code.
Select Interactive Services.
Provides status and troubleshooting information for the
LTE module.
Enroll, troubleshoot and configure Image Sensors. This
menu can also be used to retrieve images from the
enrolled Image Sensors.
View signal strength, PIR, battery and other information
about each Image Sensor enrolled.
View and configure the PIR sensitivity for the Image
Sensor.
Updated: Wed, 29 Jan 2020 21:50:59 GMT
21