Dual Assignment Instructions (Long Button Press) - Axxess AX-GMCL2-SWC Installation Instructions Manual

Note: If the next function on the list is not on the steering wheel, press the
Volume-Up button for (1) second until the L.E.D. comes on, and then release
the Volume-Up button. This will tell the AX-GMCL2-SWC that this function is not
available and it will move on to the next function.
5) To complete the remapping process, press and hold the Volume-Up button on
the steering wheel until the L.E.D. in the AX-GMCL2-SWC goes out.
Button assignment legend
1. Volume-Up
2. Volume-Down
3. Seek-Up/Next
4. Seek-Down/Prev
5. Source/Mode
6. Mute
7. Preset-Up
8. Preset-Down
9. Power
* Not applicable in this application
Note: Not all radios will have all of these commands. Please refer to the manual
provided with the radio, or contact the radio manufacturer for specific commands
recognized by that particular radio.
Steering wheel control extra settings (Cont)
10. Band
11. Play/Enter
12. PTT (Push to Talk) *
13. On-Hook *
14. Off-Hook *
15. Fan-Up *
16. Fan-Down *
17. Temp-Up *
18. Temp-Down *
®
AX-GMCL2-SWC

Dual assignment instructions (long button press)

The AX-GMCL2-SWC has the capability to assign (2) functions to a single
button, except Volume-Up and Volume-Down. Follow the steps below to
program the button(s) to your liking.
Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and
Preset-Down for a long button press.
1) Turn on the ignition but do not start the vehicle.
2) Press and hold down the steering wheel control button that you want to assign
a long press function to for about (10) seconds, or until the L.E.D. flashes
rapidly. At this point release the button; the L.E.D. will then go solid.
3) Press and release the Volume-Up button the number of times corresponding
to the new button number selected. Refer to the Dual Assignment Legend. The
L.E.D. will flash rapidly while the Volume-Up button is being pressed, and then
go back to a solid L.E.D. once released. Go to the next step once the Volume-Up
button has been pressed the desired number of times.
Caution: If more than (10) seconds elapses between pressing the Volume-Up
button, this procedure will abort, and the L.E.D. will go out.
4) To store the long press button in memory, press the button that you assigned a
long press button to (the button held down in Step 2). The L.E.D. will now go off
indicating the new information has been stored.
Note: These steps must be repeated for each button you would like to assign a
dual purpose feature to. To reset a button back to its default state, repeat Step
1, and then press the Volume-Down button. The L.E.D. will go off, and the long
press mapping for that button will be erased.
11
Continued on the next page