SMART fortwo coupe Owner's Manual page 93

Demisting the rear window
When the rear window heating is activated,
the exterior mirrors are also heated.
X
Press the ¤ button.
The indicator lamp above ¤ lights up
when the rear window heating is activated.
Use this setting only until the rear window is
clear again.
Drying windows that are misted up on the
inside
X
Press the ¿ button.
X
Press the à button.
X
If the windows are still misted up, press
the ¬ button.
Use this setting only until the windows are
clear again.
Drying windows that are misted up on the
outside
X
Switch on the windscreen wipers.
X
Press the ¬ button.
Use this setting only until the windows are
clear again.
Setting the pre-entry climate control at
departure time using the on-board com-
puter
Only for instrument cluster with colour dis-
play:
The "Pre-entry climate control at departure
time" function heats or cools the vehicle
interior before the scheduled departure time.
The climate control runs until approx. 10
minutes after the set departure time.
The vehicle must be connected to the charger
in order to activate pre-entry climate con-
trol. The battery charge and the charge out-
put of the high-voltage battery must be suf-
ficient.
If pre-entry climate control cannot be oper-
ated, a display message is shown in the on-
board computer.
X
Pre-heat/cool and charge
Call up
on-board computer.
X
Press a.
X
Select one of the following settings:
Operating the climate control system
no pre-selection
R
The pre-entry climate control is deacti-
vated.
Two stored departure times
R
X
Departure time > select
vate the stored departure time. If Smart-
Charging was selected before, this setting
is also activated.
X
Departure time > select
the settings of a stored departure time.
X
Set the value.
X
Smart-Charging
Select
ing.
A display message is shown with the selec-
ted settings.
Smart-Charging
If
voltage battery charges at minimum cost
while also conserving battery life.
Depending on the set departure time,
charging of the high-voltage battery may
not start immediately or may be interrup-
ted during the charging process.
i The charging station must support the
transmission of tariff information in order
for the optimised charging process with
Smart-Charging to be possible. If the
charging station does not provide tariff
information, set the preferred charging
times on the "smart control" website.
instant charging
i
If
high-voltage battery is charged regard-
less of the cost information. A part of the
charging may not be conducted until
one to two hours before the departure time,
in order for temperature control of the
high-voltage battery to be carried out for
the intended departure time.
Adjusting the air vents
Please note
G
WARNING
Very hot or very cold air can flow from the
air vents. This could result in burns or
frostbite in the immediate vicinity of the
in the
air vents. There is a risk of injury.
Make sure that all vehicle occupants
always maintain a sufficient distance to
Activate
to acti-
Change
to change
instant charg‐
or
is selected, the high-
is selected, the
Z
91