Table of Contents
Advertisement
ADJUSTMENT
Unplug Sander before making
adjustments.
PLATEN TABLE DISTANCE
TO SANDING DISK DISTANCE
• The proper gap between the Platen
Table and the Sanding Disk surface
is factory set at 0.063" [1.6mm]. If
adjustment is required, loosen the six
Phillips Head bolts at the underside of
the Platen Table and move in or out as
required (FIG 4).
• Use an 0.063" [1.6mm] Drill bit
(not included) as a gauge (FIG 5).
SET UP FOR USE:
• Place the Sander on a clean, dust
and grit free surface. The rubber
feet of the cast iron Sander Housing
are designed to assist with stability
during normal operation, however
it is strongly recommended that the
machine be placed on a surface, away
from any combustible materials due
to the high-velocity ejection of sparks
and high vibration levels while cutting.
If machine is to be operated on a
bench, it should be placed securely to prevent any chance of it working its way to the edge and
falling. Bolting in place or the use of C-Clamps is highly recommended.
• Keep power cord away from Sanding Disk. The unit is equipped with a 6' [1.8 m] long,
grounded, 14 ga. power cord. Plug into a properly grounded, 20 Amp outlet. If an extension
cord is required, use 14 ga. or heavier. Do not exceed 25'.
• DO NOT OVERLOAD. Sander is designed to operate with minimal pressure against Sanding
Disc. Attempts to quickly sand or grind material with excessive pressure can result in serious
personal injury, death and or serious damage to the saw.
• Secure work pieces by using the Miter Fence to prevent movement while sanding.
• The Sander Housing features a 2" O.D. outlet port suitable for connection to a an industrial
vacuum cleaner (not Included).
To order parts and supplies: 800.345.1178 >> eastwood.com
""""
FIG. 4
FIG. 5
Out
In
0.063"
Drill Bit
7
Advertisement
Table of Contents
