Programmable Thermostat (Standalone Or Local Mode Only); Set Point Override; Heating/Cooling Modes - Salus ST100ZB Manual

Section 8

Programmable Thermostat (Standalone or Local Mode Only)

When in Standalone or Local mode, the default operation of the Fan Coil Thermostat is as a Non-
Programmable Thermostat with no scheduling capability . Changing the value of Parameter P00 (See
Appendix A) to 1, changes the device to Programmable, allowing users to program a wide variety of
schedule options . Instructions for setting up a schedule are covered in Section 7: Configuration .

Set Point Override

While following a temperature schedule in any mode, the Fan Coil Thermostat will display the
The schedule may be overridden temporarily until the next programmed time period, or permanently
until the user returns the device to the programmed schedule .
• Temporary Hold
• Permanent Hold

Heating/Cooling Modes

Heating/Cooling mode selection works the same for both programmable and non-programmable Fan
Coil Thermostats . Parameter P02 (see appendix) determines which heating and/or cooling modes are
available . Pressing the MODE key, will cycle through
(Appendix A) settings . When in
the heating and cooling setpoints .
Module 5 – Connected Fan Coil Controls
Operation
To temporarily override the schedule, simply use the ^ or v keys to
change the setpoint . When in Temporary Hold, the LCD display on
the Fan Coil Thermostat will show
schedule will resume when the next scheduled time interval begins .
Change the temperature to the scheduled temperature and the
will turn off, indicating that the thermostat is following the schedule .
Once in Temporary Hold, press SELECT to toggle between temporary
and permanent override . When in permanent override, the LCD display
on the Fan Coil Thermostat the
be suspended until the user returns it to the schedule changing the
temperature to the scheduled temperature and pressing SELECT .
mode, the Fan Coil Thermostat will maintain a temperature between
in addition to the
icon will turn off . The schedule will
 depending on Parameter P02
 
icon .
icon . The
icon
8-2