Salus ST100ZB Manual page 30

Section 7
Schedule (Continued)
Set points for remaining time intervals: Set the start time and heating and/or cooling temperature for the
remaining interval for a total of 6 intervals .
Module 5 – Connected Fan Coil Controls
Device Configuration – Fan Coil Controls
Temperature Offset: Change the temperature offset value to adjust the display
of the sensed temperature . This will affect the sensor selected by the INT/EXT
sensor setting .
Use the and
range is -6 to 6°F (-3 to 3°C) .
Press SELECT to accept the set point and return to the first item in the
Settings Menu .
Time Interval: Use the
for each time interval, displayed next to the calendar icon .
1st: Set the hour for the time interval start
2nd: Set the minutes for time interval start
Press SELECT to move on to the heating setpoint .
Set Point: Use the
heating temperature set point for the time interval
displayed .
Press SELECT to accept the set point and move on to
the cooling temperature set point .
Use the or
temperature set point for the time interval displayed .
Press SELECT to accept the set point and move on to
the next interval .
Skipping a Time Interval: To skip a time interval,
press the key in the hour setting mode until each
of the time and temperature digits change to a " - " .
When time intervals are completed, the schedule
will return to the first time interval at the scheduled
time .
keys to set the offset in 1°F (0 .5°C) increments . The available
or keys to set the start time
or keys to adjust the desired
keys to adjust the desired cooling
7-3