Optional External Antenna (Sold Separately) - Salus ST100ZB Manual

Section 5
Step 3. Attach Thermostat to the Wiring Mount
by aligning the connector pins .
Make sure the connector pins are not bent and that the Thermostat is fully seated on the
wiring mount .
If an external antenna (sold separately) is required due to insufficient radio coverage, attach
the antenna, as follows, before attaching the controller to the wiring mount .

Optional External Antenna (Sold Separately):

Use the ANT10RF External Antenna if there is insufficient radio signal at the ST103ZB Wireless Remote
or SS909ZB Remote Temperature Sensor .
Module 5 – Connected Fan Coil Controls
SC102ZB Wireless Fan Coil Controller /
ST103ZB Wireless Fan Coil Remot
Step 1. Remove the antenna connector cover located on the
bottom of the SC102ZB Fan Coil Controller .
Step 2. Attach the external antenna to the connector, making
sure the nut is finger tight .
DO NOT OVERTIGHTEN the nut .
Step 4. Turn on power to the fan coil system
and thermostat .
Avoid locations that place large metal enclosures, piping
or dense electrical wires between the SC102ZB Fan Coil
Controller and the ST103ZB Wireless Fan Coil Remote .
e
5-5