Unpacking - Craftex CX Series User Manual

instructions for the proper breakers and
circuit size. When in doubt always
consult an electrician.
 Low voltage. Although the motor is
designed for operation on the voltage
and frequency specified on the motor,
which isn't a problem for normal loads
10 percent above or below that figure.
Heavy loads however require that the
voltage at the motor terminals is equal
to the voltage specified on the motor.
Magnetic On/Off Switch
The CX213 and CX214 are equipped
with a magnetic push button safety
switch that will accept a pad lock so that
the machine can be locked out to
prevent unauthorized use or during
maintenance procedures (it is always
better remove machine from its power
source). See figure 1.
Figure 1.

Unpacking

This machine is very heavy. You will
need to get assistance or power lifting
equipment such as a forklift to move this
table saw.
Removing Packing Grease
The protective coating of rust inhibitors
or packing grease prevents any rust
from forming
storage. You can remove this protective
coating by spraying
surfaces with degreaser and wiping it
clean with a shop rag. Dispose of the
soiled rags appropriately as they will
contain flammable liquids.
A putty knife held flat to the surface to
avoid scratching may also be employed
9
during shipping and
the covered