Craftex CX Series User Manual page 10

to remove built up difficult packing
grease.
To prevent rust or oxidation of your
machines surface apply a light coating
of wax or use regular applications of
aftermarket rust inhibitors.
Table Saw Placement
This machine should be installed and
operated only on solid flat level surfaces
that can support the weight of this
machine. (300lbs).
dimensions shown as a guideline in
figures 2 and 3 plan for placement within
your shop that will allow the operator to
work unobstructed by foot traffic or other
machinery.
Figure 2
Using the
10
Figure 3
Table Saw Assembly
WARNING!!!
Always wear the appropriate personal
protective equipment during the entire
setup and assembly process.
Installing the table extension wings:
Attach the table extension wings to the
main table using the supplied 8*12mm
hex head bolts (4 bolts for each wing
and 8 lock washers). Align the table
extensions with the table loosely and
attach the bolts. Now place a straight
edge on the table and table extension
as shown in figure 4 below. Once you
have aligned the table and extension
wings you can then tighten the bolds
securing the extension wings in place.
See figure 3.
Figure 3