Unpacking; Assembly - Detecto icon Owner's Manual

Carefully remove the icon Digital Clinical Scale from the shipping carton and inspect it for any
damage that may have taken place during shipment. Keep and use the original carton and
packing material for return shipment if it should become necessary. The purchaser is
responsible for filing all claims for any damages or loss incurred during transit. Remove all
plastic wrapping, foam fillers and cardboard material from scale platform, display and other
components. You should have the following components:

Column with attached Display and Sonar Bracket

Column Cover

Scale Base

Scale Base Cover

Sonar Height Rod

AC Power Adapter
TOOLS REQUIRED:
3/16" Allen wrench
#2 Phillips Screwdriver
1. Place the scale base on a level floor.
2. Insert the column cover onto the column.
3. Position the column over the opening in the scale base and then plug the modular
connector from the column into the socket in the scale base.
4. Insert the column into the scale base.
5. Using the 3/16" Allen wrench, evenly tighten the (4) Allen head screws on the back of
the scale base to secure column to scale base.
NOTE: The nuts on the front of the column opening in the scale base may turn
as you are tightening the Allen head screws.
This is normal. DO NOT use a wrench or other tool to hold the nut to keep it
from turning!
6. Slide the column cover down onto the base. Note that you may have to pull the cover
out slightly to clear the AC power jack.
7. Remove (6) screws securing sonar bracket to column and set bracket aside.
8. Align wire connector from the end of Sonar tube with the wire connector from the back
of column and plug together.
9. Insert the connector into the hole on back of column.
10. Place the sonar tube on back of the column and hold in place.
11. Place the bracket over the sonar tube and align the holes in the bracket with the holes
in the column.
IMPORTANT! Make sure the bend of the sonar tube is against the back throat of the
column.
12. Insert the screws removed earlier and using the #2 Phillips screwdriver, tighten the
screws to secure the sonar bracket to the column.
13. Place the scale base cover on the scale base and press down on both sides of the
cover. Note that a clicking sound will occur when the cover is snapped in place.
14. Scale is now ready for operation.
NOTE: For instructions on powering the scale using the AC power adapter or for
instructions on how to install batteries, refer to the INTERCONNECTIONS
section of this manual.
4

UNPACKING

ASSEMBLY

3300-0192-0M Rev D 01/17