Error And Operation Messages - Detecto icon Owner's Manual

ERROR AND OPERATION MESSAGES

The icon scale is equipped with diagnostic software that tests various portions of the scale's
circuitry and verifies proper operation. Should a problem be detected, an error or status
message will be displayed. The following lists these messages and their meaning.
AUTO LOCKED
This message appears if the weight/height has been automatically locked.
BELOW ZERO
The scale weight reading is below zero.
CAL REQUIRED
The scale requires calibration, weight will show as dashes. Consult your scale service
representative.
CENTER ZERO
The scale weight reading is at center of zero.
ERROR CANNOT ZERO
Scale cannot zero due to motion on scale.
LOCKED
This message appears if the weight/height has been manually locked.
MOTION
The scale is in motion based on motion range setting.
OVER CAPACITY
The scale weight exceeds scale capacity.
OVERFLOW ERROR
This message appears if there are too many characters to display on the screen. This
message appears if there are too many characters to display on the screen.
3300-0192-0M Rev D 01/17 23