Unpacking Instructions; Error And Status Displays - Detecto 6855KGEU Operating Instructions Manual

Waist-high stand-on scale

Hide thumbs Also See for 6855KGEU:

Specifications (2 pages)

Table Of Contents

Table of Contents

 Remove staples or cut along bottom of carton. Lift carton off pallet.

 Check for any damage incurred in shipping. If scale has been damaged, place a claim

with the carrier. It is the responsibility of the purchaser to file all claims for any damages

or loss incurred during transit. Use the original carton and shipping material to return

the scale.

 Cut packing straps securing scale to pallet.

 To remove scale from pallet, at the back of the scale lift up with equal force from the

column and at the platform base near the wheels on the scale. Set gently on floor.

 Remove all plastic wrapping, foam fillers and cardboard material from the scale.

 Remove and unpack the power supply and cord, if the scale was ordered with this

option.

 Attach indicator to indicator bracket on column, then connect load cell cable to back of

indicator. Refer to the 750 Weight Indicator Owner's Manual (8555-M483-O1) for

additional information.

ERROR AND STATUS DISPLAYS

Display

-Err-

General error, invalid keypad entry was attempted.

-OF-

Attempting to display a negative number greater than –9,999 or a

positive number greater than 99,999

Indicates an attempt to zero a weight outside scale zero range.

-trL-

(See Four Percent Zero Tracking Range Limit).

Motion is present when indicator is attempting to perform one of the

-UnS-

following operations: Power Up Zero or Zero Weight Display

CALib

Indicates calibration is necessary.

AdErr

ErrAL

ErrAH

OCAP

Scale weight exceeds scale capacity

Displayed to indicate indicator is turning off.

OFF

CARE AND CLEANING OF SCALE

 DO NOT subject the platform to sudden shocks.

 DO NOT submerge indicator in water, pour or spray water directly on indicator.

 DO NOT use acetone, thinner or other volatile solvents for cleaning.

 DO NOT expose scale to temperature extremes.

 DO NOT place scale in front of heating/cooling vents.

 DO NOT place scale in an area where it might be exposed to moisture.

 DO clean the indicator with a damp soft cloth and mild non-abrasive detergent.

 DO remove power before cleaning with a damp cloth.

 DO provide clean AC power and adequate protection against lightning damage.

 DO keep the surroundings clear to provide clean and adequate air circulation.