PIAGGIO XEVO 125 Euro 3 Service Station Manual page 45

XEVO 125 Euro 3
Replacement
Replace oil and filter as indicated in the scheduled
maintenance table. The engine must be emptied
by draining the oil through the drainage plug «B»
of the mesh pre-filter, flywheel side. furthermore,
to facilitate oil drainage, loosen the cap/dipstick
«A». Once all the oil has drained through the drain-
age opening, unscrew and remove the oil cartridge
filter «C ».
Make sure the pre-filter and discharge tap O-rings
are in good condition.
Lubricate them and refit the mesh filter and oil
drainage plug, screwing them up to the specified
torque.
Refit the new cartridge filter being careful to lubri-
cate the O-ring before fitting it.
Change the engine oil.
Since a certain quantity of oil still remains in the
circuit, engine oil must be added through the plug
«A». Then start up the scooter, leave it running for
a few minutes and switch it off: after five minutes
check the level and if necessary top up without
exceeding the MAX level. The cartridge filter must
be replaced every time the oil is changed. Use new
oil of the recommended type for topping up and
changing purposes.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS
CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Maintenance
MAIN - 11