PIAGGIO XEVO 125 Euro 3 Service Station Manual page 181

XEVO 125 Euro 3
Suspensions
- Loosen the stem support clamp and remove fork
leg and stem.
- Remove the first spring consisting of 15 windings.
- Remove the spring support plate.
- Remove the second spring consisting of 21 wind-
ings.
- Drain the oil.
- Separate the stem from the leg by removing the
screws with copper washer shown in the figure. To
prevent the rotation of the pumping insert a 12 mm
hexagonal wrench for internal parts in the stem.
- Remove the dust guard ring using a screwdriver
as shown in the figure.
- Remove the oil guard safety lock using a screw-
driver.
- Using the appropriate special tool, remove the oil
seal.
- Insert the tie rod complete with cable into the oil
guard.
- Insert the two half rings for diameter 35 mm
stems.
SUSP - 7