Komatsu Galeo PC27MR-2 Operation & Maintence Manual page 95

OPERATION
Check Oil Level in Engine Oil Pan, Add Oil
Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil
temperature to go down before performing this operation.
REMARK
If the machine is at an angle, reposition it to level before checking.
When checking the oil level after the engine has been operated, allow the engine to cool for 15 minutes before
checking.
1. Open the engine rear cover.
2. Remove dipstick (G) and wipe the oil off with a cloth.
3. Fully insert dipstick (G) into filler pipe (F), then remove it.
4. The oil level should be between the H and L marks on dipstick
(G).
If the oil level is below the L mark, add oil through oil filler (F).
5. If the oil is above the H mark, remove the undercover under the
machine, drain the excess oil from drain plug (P), then check
the oil level again.
REMARK
There is no undercover installed on the PC27MR.
6. If the oil level is correct, tighten the oil filler, then close the
engine rear cover.
7. Install the undercover.
REMARK
There is no undercover installed on the PC27MR.
MACHINE OPERATIONS AND CONTROLS
WARNING
3 - 43