Komatsu Galeo PC27MR-2 Operation & Maintence Manual page 102

MACHINE OPERATIONS AND CONTROLS
Seat Belt
Before fastening the seat belt, check that there is no problem in the securing brackets or belt. If there is any wear or damage,
replace.
Even if there appears to be no problem in the seat belt, replace the seat belt once every 3 years. The date of manufacture is
woven on the reverse side of the belt.
Adjust and fasten the seat belt before operating the machine.
Always use the seat belt when operating the machine.
Do not use the seat belt with either half of the belt twisted.
Check the mounting bolts of the belt fitting on the machine body for looseness, and retighten them if necessary.
The tightening torque for the mounting bolt is 24.5 ± 4.9 N·m (2.5 ± 0.5 kgf·m,18.1 ± 3.6 lbft).
If the belt surface is scratched or frayed or if the fittings are broken or deformed, replace the seat belt unit.
Fastening and Removing
1. Adjust the seat so that the operator still feels that there is
sufficient knee room when fully depressing the pedal while
seated, with the operator's back against the backrest.
2. After adjusting the seat position, sit in the seat. Grip buckle (1)
and tongue (2) in each hand and insert tongue (2) into buckle
(1). Pull on the belt to confirm that the tongue is securely locked
in the buckle.
3. When removing the belt, raise the tip of buckle lever (1) to
release it.
Fasten belt along your body without kinking it. Adjust the lengths of the belt on the tongue sides.
3 - 50
WARNING
OPERATION