Komatsu Galeo PC27MR-2 Operation & Maintence Manual page 69

OPERATION
Lock Lever
When leaving the operator's compartment, set the lock lever securely to the LOCK position (L). If the lock lever is not at the
LOCK position (L) and the control levers are touched by mistake, it may lead to serious personal injury.
If the lock lever is not set securely to LOCK position (L), it may cause serious personal injury. Always check that the lever is
at LOCK position (L).
When pulling the lock lever up, be careful not to touch the work equipment control lever.
When pushing the lock lever down, be careful not to touch the work equipment control lever.
This lever (1) is a device to lock the operation of the work equipment, swing, travel, and attachment.
When the lever is pulled up, it is set to LOCK position (L).
This lock lever is a hydraulic lock type, so even when it is at LOCK position (L), the control levers and pedals move,
but the work equipment and and the machine do not move.
REMARK
If the lock lever on either the left or right is not at LOCK position (L), the engine will not start.
Check that the lock lever is at LOCK position (L) before operating the starting switch.
If the engine stops when the lock lever is at FREE position (F), operate the lock lever to LOCK position (L) before
operating the starting switch.
Machine equipped with canopy
(F): Free
(L): Lock
When the left lever is pulled up, the lever stand springs up and is
locked.
When the right lever is pulled up, the lever stand does not move,
but it is locked.
Machine equipped with cab
(F): Free
(L): Lock
When the left lever is pulled up, the lever stand springs up and is
locked.
REMARK
For machines equipped with a cab, there is only a lock lever on the
left.
WARNING
DETAILED CONTROLS AND GAUGES
3 - 17