Komatsu Galeo PC27MR-2 Operation & Maintence Manual page 65

OPERATION
DETAILED CONTROLS AND GAUGES
Starting Switch
This switch (1) is used to start or stop the engine.
OFF position
The key can be inserted or with drawn. The switches for the electric
system are all turned off and the engine is stopped.
ON position
Electric current flows in the charging and lamp circuits. Keep the
starting switch key at the ON position while the engine is running.
START position
This is the engine-start position. Keep the key at this position during cranking. Immediately after starting the engine,
release the key. It will automatically return to the ON position.
HEAT (pre-heat) position
When starting the engine in cold weather, turn the key to this position. When the key is set to the HEAT position, the
engine pre-heating monitor lights up. Keep the key at this position until the engine pre-heating monitor goes out.
When the engine pre-heating monitor goes out, release the key.
When the key is released, it will return to the OFF position, so turn it immediately to START and start the engine.
Horn Switch
Press switch (2) at the center of the knob of the right work
equipment control lever to sound the horn.
Lamp Switch
Use this switch (3) to turn on the headlamps and the lamp inside the machine monitor.
For details, see MONITOR SWITCHES, "Lamp Switch (PAGE 3-10)".
Travel Speed Selector Switch
Use this switch (4) to switch the travel speed to low speed or high speed.
For details, see MONITOR SWITCHES, "Travel Speed Selector Switch (PAGE 3-11)".
3 - 13