Routing The Aap Cables; Bezels - Extron electronics HSA 802 User Manual

im Vertrieb von
Installation, cont'd
If necessary, on the front panel, have a qualified service person
replace the connector icon by prying the old icon off of the
connector plug-in with a tweeker (figure 2-9) and snapping a
new icon in place.
Icon Labels
Figure 2-9 — Changing the connector icon
AC power connector — Plug a standard IEC power cord into
2
this connector to connect the enclosure to the appropriate power
source:
125VAC, 60 Hz (US-domestic version)
100-240VAC, 50/60 Hz (IEC version)
230VAC, 50/60 Hz (UK or Australian versions)
240VAC, 50/60 Hz (European version)
Cable access holes
3
Spare front panel screws
4

Routing the AAP cables

The AAP cables must have freedom of movement to permit
opening and closing the surface mount enclosure. At the same
time, they need to be restrained to prevent their rubbing against
the edges of the enclosure cable access hole in the underside of
the surface mount enclosure. Rubbing against the cable access
hole edges can damage the cables. Route and secure the AAP
cables as follows:
Open the top panel to extend the AAP cables to their
1.
maximum pull.
2. Experiment with AAP cable positioning to ensure that the
cables do not rub against the edges of the AAP cable hole
(Figure 2-6, ) and to ensure that the cable pull does not
3
restrict the movement of the top panel. Figure 2-10 shows
the cables routed to the side, which proved effective in
tests at Extron.
www.camboard.de
2-10 Surface Access Products • Installation
CAMBOARD Electronics

Bezels

Tel. 07131 911201
Fax 07131 911203
Secure AAP cables here
Secure AAP cables here
View A
Figure 2-10 — HSA 802 AAP cable routing
3. Use tie wraps to secure the AAP cables to the tie-down
holes in the clamshell and enclosure in the locations
shown.
The HSA 800/802 ships with RJ-45 connector bezel plug-ins in a
variety of colors and a black, blank bezel.
To change to a different color RJ-45 connector bezel or if an
RJ-45 connector is not needed or desired, replace the connector
bezel plug-in on the front panel with a bezel of a different color
or a blank plug-in. See Replacing the Bezels in chapter 3.
If no RJ-45 connector is desired, snap the interior RJ-45 cable
onto the rear of the blank bezel plug-in to hold it conveniently
out of the way. Retain the removed connector bezel plug-in for
any possible later use.
ce-info@camboard.de
Surface Access Products • Installation
View B
2-11