Hammerhead 100XT Operator's Manual page 81

100XT Operator's Manual
As Needed
Replace Rod Catcher
1. Remove bolts holding plastic guides in place.
2. Remove worn guides.
3. Reinstall new guides using existing hardware.
Replace Rod Wiper
IMPORTANT: Install rod wiper with X facing
outward and at top center.
1. Lift off front of machine. See "Remove/Install
Front Panel" on page 72.
2. Remove rod wiper (shown).
3. Lower front panel down into place.
Lube Rod/Pipe Threads
Lube with RJL antiseize lubricant as needed.
NOTICE:
• Apply lubricant to female threads only.
• If rod/pipe threads are damaged, replace
immediately.
• Ensure rods/pipes are free from any dirt or
debris.
80 - Service
j51om005w.eps
j51om006w19.eps
DrillPipe_CleanF.eps