Emergency Stop Procedure; Lock/Unlock Bungee; Lock Bungee - Hammerhead 100XT Operator's Manual

100XT Operator's Manual

Emergency Stop Procedure

To shut down power unit engine under normal conditions, use key switch or emergency stop on power unit.
To shut down power unit using remote controller, press the remote stop switch on remote controller.

Lock/Unlock Bungee

To help avoid injury: Turn power unit off before handling bungee fork.
IMPORTANT: For unit components, see "Bursting Unit Components" on page 5. For controls, see
"Remote Controller" on page 29.

Lock Bungee

When bungee is locked, rod will only move
backward. To move rod forward, unlock bungee.
1. Open clamp.
2. Remove bungee fork from unlock position.
3. Move carriage to front of unit to compress
bungee.
4. Insert bungee fork in the lock position
(shown).
Pinch points can crush. Keep hands clear.
j51om001w19.eps
Emergency Stop Procedure
Burst Pipe - 53