Hammerhead 100XT Operator's Manual page 62

100XT Operator's Manual
2. Continue pulling back rod string until bursting/splitting assembly reaches pit.
3. Connect one rod onto rod in bursting unit.
4. If not already in place, move bursting unit back in pit and position extraction cage between bursting
unit and existing pipe and pit wall.
IMPORTANT: Ensure extraction cage is level and centered. Move bursting unit forward until it is
firmly against extraction cage.
5. Put bursting unit in pull mode and pull bursting/splitting system into extraction cage.
6. Remove extraction cage.
7. Disconnect and remove bursting/splitting system.
8. Remove bursting unit from pit.
9. Connect both ends of new product to existing pipe to complete job.
Pull New Product
Burst Pipe - 61