Installation; Precaution; Installation 2.1 Precaution - GCC Technologies P3-60 User Manual

Chapter 2 Installation
2.1

Precaution

Notice 1
 Carefully handle the cutter to prevent any injuries.
 Make sure the power switch is off before installing the cutting plotter.
Notice 2 A proper place for installation the cutting plotter
Please select a proper location that meets the following conditions.
 The machine can be approached easily from any direction.
 Keep at least 60 cm space in front and behind the machine.
 Make sure the cutter is placed on a flat, level and sturdy surface
 The operation temperature should be between 15 and 30
workshop.
 Keep the relative humidity between 25% and 75% in the workshop.
 Protecting the machine from dust and air current.
 Preventing the machine from direct sunlight.
Notice 3 Connecting the Power Supply
Check the plug of the power cord to see if it matches the wall outlet. If not, please
contact your dealer.
 Insert the plug (male) into a grounded power outlet.
 Insert the other end (female) of power cord into the AC connector of cutting
plotter.

Installation

2-1
Puma III User Manual
o
℃
(60-86 F) in the