Replacement Of Pinch Roller Set And Lever Assembly - GCC Technologies Puma Series Maintenance Manual

Replacement of Pinch Roller Set and Lever Assembly

Refer to Fig 1-2 to 1-3 to remove the pinch roller set or lever assembly.
1. Remove the Square Bar Holding Bracket.
Loosen and remove the two screws that fix the bracket to the carriage guide beam.
2. Remove Pinch Roller Set
Step 1. Move the Pincher Roller Set to the furtherest end (view from rear) where a notch is on
the guide beam.
Step 2. Remove the Pinch Roller Set from the notch.
To install, please keep the inside Cam Roller of the Pinch Roller Set downward squarely and
Lever up.
Front
Front
Square Bar Holding Bracket
Cam roller pointing
downward squarely when
Cam roller pointing
installing
downward squarely when
installing
Fig 1-2
26