Connect Smoke Detectors - Siemens Synco 900 Mounting And Commissioning

Hide thumbs Also See for Synco 900:

Operating instructions manual (76 pages)

Basic documentation (120 pages)

Table Of Contents

Table of Contents

The connection of the heating circuit controller is made individually for

each required channel.

To connect a heating circuit controller channel, press the channel

selection button (CH) to select a suitable channel (channels Y1 and

Y2 with the RRV912, channels 1..8 with the RRV918). The LED of

the selected channel blinks. If the selected channel is not yet con-

nected, the connection LED flashes.

If no button is pressed for 10 minutes, the heating circuit con-

troller returns to normal operation.

Now, press the multifunction button on the heating circuit controller.

The LED lights up green. As soon as it starts blinking, you can re-

lease the binding button.

The first channel of a room that has been connected assumes

lead control. The other channels of the same room that have

been connected is controlled in parallel.

After successful connection, the heating circuit controller is restarted.

Now, the heating circuit controller has returned to channel selection

mode and is ready for connecting another channel.

Connect window contacts

The window / door contact wave AP 260 is ready to operate as soon

as the inserted batteries supply power.

For detailed information, refer to the documentation covering

the GAMMA wave products.

The door / window contact is connected by pressing the multifunction

button on the door or window contact for at least one second. If the

learning telegrams were forwarded, the LED blinks for about 3 sec-

onds.

To confirm the successful connection, the central apartment unit de-

livers a beep. When all devices of the room are connected, close the

binding process by pressing the Menu/ok button.