Table of Contents
Advertisement
Initial Control Settings
Before beginning the start-up procedures for the cooker, the instruction plate and service manual for
the steam boiler must be consulted and all start-up procedures completed to supply 15 PSI steam to the
steam inlet line for the cooker.
1. All steam boiler controls are in the operating mode and 15 PSI steam is applied to the cooker
inlet plumbing.
2. Cooker timers for both compartments (see Figure 2 on page 9) are in the OFF position.
3. Cooker compartments are empty of all information materials, pan supports are mounted in
place, and doors are open.
Cooker Check-Out
The cooker check-out procedures are as follows:
1. With the doors open set timers to about the "4-minute" position. Observe that indicator lights
are off and steam does not enter compartments.
2. Close cooker compartment doors. Observe that indicator lights turn on, and steam can be heard
rushing into the compartment simultaneously with the door closing.
3. Observe the boiler drain line for passage of steam into the open floor drain. Correct steam
condenser operation is evidenced by presence of water flowing from the drain line.
4. Observe cooker operation for several minutes. Operation is correct if timer dials begin to rotate
after a short delay period required for preheating. After the delay period plus the "4-minute"
initial setting, the timer dials will return to the "0-Minute" position, at which a buzzer sounds.
The buzzer is silenced by turning the dial to the OFF position.
Shut-Down Procedure
No shut-down procedure is required for the Pressureless Cooker except to check that all timer dials (2)
are in the OFF position and the compartment doors are open. Consult the steam boiler instruction plate
and complete the shut-down procedures for the boiler.
REVERSING THE DOORS
The Pressureless Steam Cooker has a reversible cooking compartment door. This section contains
instructions for reversing this door.
1. Turn off power to the unit.
2. Open the cooking compartment door
3. Remove the two screws that attach the top hinge to the front of the unit.
4. Slide the door upwards, off the bottom hinge.
5. Remove the two screws that attach the bottom hinge to the front of the units.
6. Remove the right and left side panels by unscrewing the 1 screw on each panel and sliding the
panel down.
4
Advertisement
Table of Contents
