Rear Panel; Power Supply; Input And Output Signals - Estun E10 Operation Manual

3.5 Rear Panel

3.5.1 Rear panel
On the rear panel (Figure 3-1) , there are input instructions, output instructions, encoder interface and
connection port (wirings see appendix). The significance of the indicator light will make the following
introduction.
AC1 AC2 GND

3.5.2 Power supply

AC1 --------------------------- power supply of +24 V, or one end of AC power.
AC2 --------------------------- power supply of 0 V, or the other end of AC power.
GND --------------------------
+24 V --------------------------

3.5.3 Input and output signals

IN1 --------------------------- input channel 1 input (shears for shearing count input signal).
IN2 --------------------------- input channel 2 input.
OUT1 --------------------------- output channel 1 output.
OUT2 --------------------------- output channel 2 output.
OUT3 --------------------------- output channel 3 output.
OUT4 --------------------------- output channel 4 output.
0V --------------------------- common port of input and output channels.
24V --------------------------- common port of output channels.
IN1 IN2 OUT1 OUT2 OUT3 OUT4
+24V IN1 IN2 OUT1 OUT3 OUT4
0V OUT2
Figure 3-1 Rear Panel
GND.
24 V.
Page 5 of 28
E10 Operation Manual V1.15
24V