Chapter 5 Parameters; Set A Parameter - Estun E10 Operation Manual

Chapter 5

5.1 Set a parameter

Power on, press
display shows the parameter num and the second line shows the value of the parameter. Only
the value of flashing digit can be edited.
1. Find out the teach-in parameter number that need to be changed
Press numerical keys to change the existing value and press the positioning keys to select
the digit to be changed. After entering the new value, press
2. Edit the contend of the parameters
Press numerical keys to change the existing value and press the positioning keys to select
the digit to be changed. After entering the new value, press
Notice:
1. Edit of current positions of X-axis and Y-axis must be performed with power OFF.
2. The parameters of machine tools must be set first and then the teach-in parameters if
it is the first time setting the parameters.
3. Every parameter has its range. If the preset value exceeds the range, then the
parameter will be the max limits as its value.
I will show you how to change the value of parameter 'PAC02' as "100.0" (It is supposed
the original value of parameter 'PAC02' is "0.0")
Press to enter 'teach-in' parameter interface.
Then the first line of digital display shows 'PAC 01' and the last digit "1" will flash.
(increase key) to edit '1' to '2' and press
Press
After that, the digits of first line will all flash once and digit "1" stops flashing. While
second line displays 0.0, and the last digit "0" will flash.
Press (the leftward moving key) for 3 times, and digit "0" on the fourth will be
flashing.
(increase key) to edit '0' to '1' ,then the second line will display 100.0 and
Press
digit "1" is flashing.
(enter key) to confirm the edit. After that, all digits of the second line will
Press
flash.
Parameters
to enter each parameter interface. Then the first line of digital
Page 14 of 28
E10 Operation Manual V1.15
(enter key) to confirm.
(enter key) to confirm.
(enter key).