Appendix 1 Q&A - Estun E10 Operation Manual

E10 Operation Manual V1.15
Appendix 1 Q&A
1. Power on, the system has no display. Check the power supply access is correct.
2. If the machine is in run-time, the location of axis does not show or change, check the encoder cable is
well-connected.
3. If the system has the input signal but no output signal, then check the timing relay settings are set
correctly, and then check the indicator light of corresponding input channel is lit.
4. If the difference between the display value and actual value of the location is too much, please check the
multiplication factor, division factor parameters setting is correct.
5. If the counting num keeps zero all the time, please check the shearing count signal accesses to the
corresponding input channel correctly.
Page 24 of 28