Installing The 3200P Ph Meter - Agilent Technologies 3200P User Manual

Installing the 3200P pH Meter

Large nut
Small nut
Flexible arm
Small nut
Electrode holder
Large nut
Electrode holder base
Figure 1 Installing the Electrode holder
3200P pH Meter User Guide
Open the meter kit package case. Remove the pH Meter,
multifunction electrode holder, and other parts.
The sockets for the pH electrode and ATC probe are on the
back panel of the meter. Insert the connectors of the pH
electrode and ATC probe (5190- 3998) into their respective
sockets. See Figure 6
along the electrode holder as shown in
on page 13. Run the electrode cables
Figure 2
Installation 1
Setscrew
on page 8.
7