To Manually Set The Solution Temperature - Agilent Technologies 3200P User Manual

To manually set the solution temperature

3200P pH Meter User Guide
During a measurement in this mode, you can view
measuring parameters, calibrate the electrode, and so
forth. After measurement ends, you can save and output
the results.
Press [Cancel] to exit this mode or press [Measure] to
begin the next measurement.
If using an ATC probe (an ATC probe is connected to the
meter), the meter uses the temperature data from the probe.
Otherwise, the user must enter the temperature value of the
sample solution.
Figure 12 Entering temperature
1 Press [Setup] and select Set Manual Temp.
2 Enter the temperature in the dialog.
Operation 2
27