Terminal Block - Banner SureCross DX80N9X1S2N1M1 Manual

SureCross DX80 Node with Integrated Battery
Warmup Time
Voltage
0 Volts
Sample point

Terminal Block

SW2
SW1
A2
A1
GND
DO2
DO1
GND
DI2
DI1
For FlexPower devices, do not apply more than 5.5V to the gray wire. Do not apply power to the Ax+ connection.
Wiring Diagrams for Discrete Inputs
Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram
refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the wiring board.
Discrete Input Wiring for PNP Sensors
PWR
10-30V dc
DIx
Wiring Diagrams for Analog Inputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
Analog Input Wiring (10 to 30V dc Pow-
er)
PWR
10-30V dc
AIx
+ −
sensor
GND
dc common
P/N 147502 Rev. E
Switch Power
Sample interval
AIx or Ax. Analog IN x.
BAT. 3.6 to 5.5V dc power connection when powered by DX81 or DX81P6
BAT
Battery Supply Modules.
GND
RX
DIx. Discrete IN x.
TX
DOx. Discrete OUT x.
GND. Ground/dc common connection.
RX/-. Serial comms line
SWx or SPx. Switch Power. Provides variable power sources for external
devices.
TX/+. Serial comms line
Analog Input Wiring (4–20mA, 2-Wire,
Externally Powered Sensors)
+
external power
sensor
dc common
www.bannerengineering.com - tel: 763-544-3164
Sample point
Discrete Input Wiring for NPN Sensors
DIx
GND
dc common
Analog Input Wiring (4–20mA, 2-Wire,
Switch Powered Sensors)
AIx
−
GND
dc common
SPx
+
AIx
−
+ −
sensor
GND
5