Oracle Solaris Cluster 3.3 System Manual page 20

Installing Storage Arrays
h. Instruct the OpenBoot PROM (OBP) Monitor to use the nvramrc script, as shown in the
following example.
{0} ok setenv use-nvramrc? true
use-nvramrc? = true
{1} ok
If you are not installing new host adapters in Node B, skip to
10
If you are installing new host adapters in Node B to connect Node B to the storage array or
11
storage system, shut down and power off the node.
For the procedure about how to shut down and power off a node, see your Oracle Solaris
Cluster system administration documentation. For a list of Oracle Solaris Cluster
documentation, see
Install the host adapters in Node B.
12
For the procedure about how to install host adapters, see the documentation that shipped with
your nodes.
Cable the storage array or storage system to Node B.
13
For cabling diagrams, see
If you did not power off Node B to install a host adapter, skip to
14
If you powered off Node B to install a host adapter, power on Node B and the storage array or
15
storage system.
Do not enable the node to boot. If necessary, halt the system to continue with OpenBoot PROM
(OBP) Monitor tasks.
Verify that Node B recognizes the new host adapters and disk drives.
16
If the node does not recognize the new hardware, check all hardware connections and repeat the
installation steps you performed in
{0} ok show-disks
...
b) /sbus@6,0/QLGC,isp@2,10000/sd...
d) /sbus@2,0/QLGC,isp@2,10000/sd...{0} ok
Verify that the scsi-initiator-id is set correctly on the second node.
17
a. If necessary, power on the second node, but do not allow it to boot. If necessary, halt the
system to continue with OBP Monitor tasks.
20 Oracle Solaris Cluster 3.3 With StorEdge A1000 Array, Netra st A1000 Array, or StorEdge A3500 System Manual
• May 2011, Revision A
"Related Documentation" on page
"Adding a Sun StorEdge A3500 Storage System" on page
Step 12.
Step 13.
6.
Step 17.
51.