Oracle Solaris Cluster 3.3 System Manual page 13

Ensure that each device in the SCSI chain has a unique SCSI address.
3
To avoid SCSI-chain conflicts, the following steps instruct you to reserve SCSI address 7 for one
host adapter in the SCSI chain and change the other host adapter's global scsi-initiator-id
to an available SCSI address. Then the steps instruct you to change the scsi-initiator-id for
local devices back to 7.
A slot in the storage array might not be in use. However, do not set the
Note –
scsi-initiator-id to a SCSI address for that disk slot. This precaution minimizes future
complications if you install additional disk drives.
a. If necessary, power on the storage devices.
If necessary, halt the nodes so that you can perform OpenBoot PROM (OBP) Monitor
Note –
tasks at the ok prompt.
For the procedure about powering on a storage device, see the service manual that shipped
with your storage device.
b. If necessary, power on a node, but do not allow it to boot. If necessary, halt the system to
continue with OBP Monitor tasks.
c. Set the scsi-initiator-id for one node to 6.
{1} ok setenv scsi-initiator-id 6
scsi-initiator-id = 6
d. Find the paths to the host adapters that connect to the local disk drives.
{0} ok show-disks
Use this information to change the SCSI addresses in the nvramrc script. Do not include the
/sd directories in the device paths.
e. Edit the nvramrc script to set the scsi-initiator-id for the local devices on the first node
to 7.
For a full list of commands, see the
Insert exactly one space after the first double quote and before
Caution –
scsi-initiator-id.
{0} ok nvedit
0: probe-all
1: cd /pci@1f,4000/scsi@2
2: 7 encode-int " scsi-initiator-id" property
3: device-end
4: cd /pci@1f,4000/scsi@3
Chapter 1 • Installing and Maintaining a SCSI RAID Storage Device
OpenBoot 2.x Command Reference
Installing Storage Arrays
Manual.
13