Table of Contents
Advertisement
Shut down the node.
7
For the procedure about how to shut down and power off a node, see your Oracle Solaris
Cluster system administration documentation. For a list of Oracle Solaris Cluster
documentation, see
To create the new Oracle Solaris device files and links, perform a reconfiguration boot by adding
8
-r to your boot instruction.
Repeat
9
storage system.
Return to
10
Maintaining Storage Arrays
The maintenance procedures in
Maintenance Procedures" on page 32
Table 1–3
Note –
size of a LUN, or perform other LUN operations, a device ID might change unexpectedly. When
you perform a check of the device ID configuration by running the cldevice check command,
the following error message appears on your console if the device ID changed unexpectedly.
device id for nodename:/dev/rdsk/cXtYdZsN does not match physical
device's id for ddecimalnumber, device may have been replaced.
To fix device IDs that report this error, run the cldevice repair command for each affected
device.
TABLE 1–3
Task
Remove a storage array or storage system
Replace a storage array or storage system
Replacing a storage array or storage system, requires first
removing the storage array or storage system, then adding a new
storage array or storage system to the configuration.
Replace a failed controller module or restore an offline controller
module
Chapter 1 • Installing and Maintaining a SCSI RAID Storage Device
"Related Documentation" on page
Step 1
through
Step 8
on the other node. This node is attached to the storage array or
"How to Create a LUN"on page
lists the procedures that require cluster-specific steps.
When you upgrade firmware on a storage device or on an enclosure, redefine the stripe
Task Map: Maintaining a Storage Array or Storage System
6.
22.
"FRUs That Do Not Require Oracle Solaris Cluster
are performed the same as in a noncluster environment.
Maintaining Storage Arrays
Information
"How to Remove a Storage Array" on
page 34
"How to Add a Storage Array to an Existing
Cluster" on page 16
"How to Remove a Storage Array" on
page 34
"How to Replace a Failed Controller or
Restore an Offline Controller" on page 37
31
Advertisement
Table of Contents
