This procedure relies on the following prerequisites and assumptions.
Before You Begin
Your cluster is operational.
■
This procedure defines Node A as the node with which you begin working. Node B is the
■
remaining node.
This procedure uses an updated method for setting the scsi-initiator-id. For this
■
storage array, the method that was published in earlier documentation is still applicable.
However, if your cluster configuration uses a Sun StorEdge PCI Dual Ultra3 SCSI host
adapter to connect to any other shared storage, you need to update your nvramrc script and
set the scsi-initiator-id by using this procedure.
This procedure provides the long forms of the Oracle Solaris Cluster commands. Most
commands also have short forms. Except for the forms of the command names, the commands
are identical.
To perform this procedure, become superuser or assume a role that provides
solaris.cluster.read RBAC (role-based access control) authorization.
Install the RAID Manager software.
1
For the required version of the RAID Manager software that Oracle Solaris Cluster software
■
supports, see
For the procedure about how to install RAID Manager software, see the Sun StorEdge RAID
■
Manager Installation and Support Guide.
For the most current list of software, firmware, and patches that your storage array or
■
storage system requires, refer to the appropriate EarlyNotifier that is outlined in
Documentation" on page
and to customers with service contracts at
Install the storage array or storage system patches.
2
For the location of patches and installation instructions, see your Oracle Solaris Cluster release
notes documentation. For a list of Oracle Solaris Cluster documentation, see
Documentation" on page
Set the Rdac parameters in the /etc/osa/rmparams file.
3
Rdac_RetryCount=1
Rdac_NoAltOffline=TRUE
Power on the storage array or storage system.
4
For the procedure about how to power on the storage array or storage system, see your storage
documentation. For a list of storage documentation, see
If you are not installing new host adapters in your nodes, skip to
5
Chapter 1 • Installing and Maintaining a SCSI RAID Storage Device
"Restrictions and Requirements" on page
6. This document is available online to Oracle service providers
6.
11.
My Oracle
Support.
"Related Documentation" on page
Step
8.
Installing Storage Arrays
"Related
"Related
6.
17