Ranger R76LT Installation And Operation Manual page 26

As a general rule, you clamp steel Wheels internally (Clamps push out against Wheel) and custom
and mag Wheels externally (Clamps push in against outside Rim edge). Check with your
Supervisor if you are unclear about which method to use for a particular set of Wheels.
To clamp externally
out (they may be all the way out already), put the Wheel between the Clamps, then press down on
the Clamps Foot Pedal to move the Clamps in until the Wheel is being firmly held in place.
To clamp internally
in (they may be all the way in already), position the Wheel over the Clamps, then press down on
the Clamps Foot Pedal to move the Clamps out until the Wheel is being firmly held in place.
Note:
• Clamp Adjustment Knobs. Move the Clamp between three different positions within the
Clamp Mechanism to accommodate Wheels of different sizes.
To move a Clamp
you want to move the Clamp, slide the Clamp in the desired direction, release the Clamp
Adjustment Knob. If you want to move the Clamp again in the same direction, repeat the same
procedure with the other Clamp Adjustment Knob.
If the Clamp is in the center position, you can only move the Clamp one position in either direction.
R76 Series of Tire Changers
: If necessary, use the Clamps Foot Pedal to move the Clamps all the way
: If necessary, use the Clamps Foot Pedal to move the Clamps all the way
The Clamps Foot Pedal works as follows: If the Clamps are in the middle of the Turntable
(all the way in), pressing down and then releasing the Clamps Foot Pedal moves them all
the way out. If the Clamps are all the way out, pressing down and then releasing the
Clamps Foot Pedal moves them all the way in.
: Pull out and hold out the Clamp Adjustment Knob closest to the direction
26
P/N 5900346 — Rev. C — Dec. 2019