Appendix B: Installing The Lap-Teq Inclinometer On A10-Bump - L-Acoustics A10 Owner's Manual

Installing an inclinometer on A10-BUMP
Tools
• torque screwdriver
• T20 Torx bit
• 7 mm wrench
About this task
A10-BUMP is equipped with a support plate for installing an optional inclinometer. Three models are compatible:
® LAP-TEQ PLUS (provided in the TECH TOOLCASE), TEQSAS
TEQSAS
Compact.
LAP-TEQ / LAP-TEQ PLUS sensor and display compatibility
The legacy LAP-TEQ sensors are compatible with the new TEQSAS
Conversely, the new sensors are not compatible with the legacy displays.
With two sets of xation points and slit openings, the position and orientation of the laser support plate can be adapted
to every use of the rigging frame.
fixation points (left)
slit openings
Calibrating the inclinometer
Refer to the manufacturer instructions.
An additional XLR cable is needed.
Exploded view
Use the screws and nuts provided with A10-BUMP.
Before tightening the screws, align the laser with the slit opening.
A10 owner's manual (EN) version 1.1
fixation points (right)
3 N.m
7 mm
Installing an inclinometer on A10-BUMP
®
LAP-TEQ (legacy model), and KSG
®
LAP-TEQ PLUS displays.
T25
®
RECLINE
141