L-Acoustics A10 Owner's Manual page 83

Preparing a block of enclosures
About this task
This procedure is optional and requires two operators
A single operator must assemble the enclosures one by one. Refer to
Procedure
1. Separate the array into blocks of two or three enclosures.
Connect each enclosure on both sides before adding the new one.
This step requires two operators.
Make sure all unused rigging arms are in storage position.
2. Position the enclosure blocks upright (logo on top) in two steps.
Tilt the enclosures on the rear.
3. Proceed as described in
A10 owner's manual (EN) version 1.1
Assembly (p.80).
Assembly (p.80).
Tilt the enclosures upright.
Rigging procedures
83