Appendix A: Installing An Inclinometer On Kibu-Sb - L-Acoustics Kiva II Owner's Manual

Installing an inclinometer on KIBU-SB
Tools
• torque screwdriver
• T20 Torx bit
• 7 mm wrench
About this task
KIBU-SB is equipped with a support plate for installing an optional inclinometer. Three models are compatible: TEQSAS
LAP-TEQ PLUS (provided in the TECH TOOLCASE), TEQSAS
LAP-TEQ / LAP-TEQ PLUS sensor and display compatibility
The legacy LAP-TEQ sensors are compatible with the new TEQSAS
Conversely, the new sensors are not compatible with the legacy displays.
slit opening
support plate for laser
Calibrating the inclinometer
Refer to the manufacturer instructions.
An additional XLR cable is needed.
Exploded view
Use the screws and nuts provided with KIBU-SB.
Before tightening the screws, align the laser with the slit opening.
3 N.m
Kiva II owner's manual (EN) version 3.0
T20
LAP-TEQ mounted on KIBU-SB.
®
LAP-TEQ (legacy model), and KSG
®
LAP-TEQ PLUS displays.
7 mm
Installing an inclinometer on KIBU-SB
®
RECLINE Compact.
®
121