Miele SmartLine CS 7632 Operating And Installation Instructions page 38

Problem solving guide
Problem
After the SmartLine
appliance has been
switched on,  appears
briefly in the timer
display. The SmartLine
appliance does not heat
up.
The Teppanyaki or a
Teppanyaki zone
switches off
automatically.
An operating noise can
be heard after the
SmartLine appliance
has been switched off.
The sensor controls
show increased
sensitivity or fail to
react.
 flashes alternately
with  in the timer
display and a tone is
sounding.
38
Possible cause and remedy
The SmartLine appliance is in demonstration mode.
 Touch the 0 and 2 sensor controls at the same
time until  flashes alternately with  in the
timer display.
It has been operated for too long.
 Switch the Teppanyaki or the zone back on (see
"Safety features – Safety switch-off").
The overheating protection mechanism has been
triggered.
 See "Safety features - Overheating protection".
The cooling fan runs until the SmartLine appliance
has cooled down and then switches off
automatically.
The sensitivity level of the sensor controls has
changed.
 Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the
SmartLine appliance. Also ensure the area
surrounding the SmartLine appliance is not too
dark.
 Take any pans off the SmartLine appliance and
wipe away any food deposits.
Ensure that there is nothing covering the entire
SmartLine appliance or sensor controls.
 Interrupt the power supply to the SmartLine
appliance for approx. 1 minute.
 If the problem persists after power is restored,
please contact Miele.
The SmartLine appliance is connected incorrectly.
 Disconnect the SmartLine appliance from the
mains.
 Contact Miele.