Table of Contents
Advertisement
Overheating protection
All the induction coils and cooling
elements for the electronics are fitted
with an overheating protection
mechanism. Before the induction coils
and/or cooling elements get too hot, the
overheating protection mechanism cuts
in in one of the following ways:
Induction coils
– The set power level is reduced.
– The Teppanyaki zone switches off
automatically. flashes alternately
with in the timer display.
You can use the Teppanyaki zone again
as usual as soon as the fault code has
gone out.
Cooling elements
– The set power level is reduced.
– The Teppanyaki zone switches off
automatically.
The affected Teppanyaki zone can only
be used again as usual once the
cooling element has cooled down to a
safe level.
The overheating protection may be
triggered under the following
circumstances:
– Fat or oil being heated on a high
power level.
– Insufficient ventilation to the
underside of the Teppanyaki.
– A hot Teppanyaki zone being
switched on after an interruption to
the power supply.
If, despite removing the cause, the
overheating protection mechanism
triggers again, contact Miele.
Safety features
31
Advertisement
Table of Contents
